ZyXEL Communications LTE5366 Series, Руководство пользователя

Страница: 62 / 228

Chapter 6 WAN
LTE5366 Series User’s Guide
62
6.5 Network Scan
Use this screen to set how you want the LTE5366 to connect to an available mobile network. Click
Network > WAN > Network Scan from the Configuration menu.
Figure 34 Configuration > Network > WAN > Network Scan
The following table describes the labels in this screen.
IGMP Select Auto to enable multicasting. This applies to traffic routed from the WAN to the LAN.
Select Disable to turn off this feature. This may cause incoming traffic to be dropped or
sent to all connected network devices
IGMP Proxy This field is available only when IGMP is enabled.
Select this option to have the LTE5366 act as an IGMP proxy on this connection. This
allows the LTE5366 to get subscribing information and maintain a joined member list for
each multicast group. It can reduce multicast traffic significantly.
IP Type Select IPv4 if you want the LTE5366 to run IPv4 only.
Select IPv6 if you want the LTE5366 to run IPv6 only.
Select IPv4/IPv6 if you want the LTE5366 to run IPv4 and IPv6 at the same time.
Save Click Save to save your changes back to the LTE5366.
Undo Click Undo to reload the previous configuration for this screen.
Table 16 Configuration > Network > WAN > Management WAN Edit (continued)
LABEL DESCRIPTION
Table 17 Configuration > Network > WAN > Network Scan
LABEL DESCRIPTION
Physical Interface This shows the type of the interface used by the WAN connection.
Network Type Select the type of the network ( 4G only ) to which you want the LTE5366 to connect when
there is a SIM card inserted.