ZyXEL Communications LTE5121, Руководство пользователя

Страница: 46 / 234

Chapter 5 Wireless
LTE-5121 User’s Guide
46
The following table describes the labels in this screen.
Table 7
Network > Wireless LAN > General
LABEL DESCRIPTION
Wireless Network Setup
Wireless Select the Enable Wireless LAN check box to activate the wireless LAN.
Note: You must also set the LTE Device’s physical WLAN ON/OFF button to ON to
use wireless LAN. The WLAN LED should be on.
Wireless Network Settings
Wireless
Network Name
(SSID) The SSID (Service Set IDentity) identifies the service set with which a wireless
device is associated. Wireless devices associating to the access point (AP) must
have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the wireless
LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
BSSID This shows the MAC address of the wireless interface on the LTE Device when
wireless LAN is enabled.
Mode Select This makes sure that only compliant WLAN devices can associate with the LTE
Device.
Select 802.11b/g/n to allow IEEE 802.11b, IEEE 802.11g and IEEE 802.11n
compliant WLAN devices to associate with the LTE Device. The transmission rate of
your LTE Device might be reduced when an 802.11b or 802.11g wireless client is
associated with it.
Select 802.11b/g to allow both IEEE 802.11b and IEEE 802.11g compliant WLAN
devices to associate with the LTE Device. The transmission rate of your LTE Device
might be reduced.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the LTE Device. Select 802.11n only in 2.4G band to allow only
IEEE 802.11n compliant WLAN devices with the same frequency range (2.4 GHz) to
associate with the LTE Device.
Note: The transmission rate varies depending on the mode the wireless client uses to
associate with the LTE Device.
Channel
Selection Set the channel depending on your particular region.
Select a channel or use Auto to have the LTE Device automatically determine a
channel to use. If you are having problems with wireless interference, changing the
channel may help. Try to use a channel that is as many channels away from any
channels used by neighboring APs as possible. The channel number which the LTE
Device is currently using then displays in the Operating Channel field.
Scan Click this button to have the LTE Device immediately scan for and select a channel
(which is not used by another device) whenever the device reboots or the wireless
setting is changed.
Operating
Channel This is the channel currently being used by your AP.
Security Level