ZyXEL Communications LTE3301-M209, Руководство пользователя, Страница: 72 / 189

Chapter 7 Wireless LAN
LTE3301-M209 User’s Guide
72
The following table describes the labels in this screen.
7.5 MAC Filter Screen
The MAC filter screen allows you to configure the Zyxel Device to give exclusive access to devices
(
Allow ) or exclude devices from accessing the Zyxel Device ( Deny ). Every Ethernet device has a unique
MAC (Media Access Control) address. The MAC address is assigned at the factory and consists of six
pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC address
of the devices to configure this screen.
To change your Zyxel Device’s MAC filter settings, click Network > Wireless LAN > MAC Filter . The screen
appears as shown.
Table 25 Network > Wireless LAN > More AP: Edit
LABEL DESCRIPTION
Active Select this to activate the SSID profile.
Name (SSID) The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is associated.
Enter a descriptive name (up to 32 printable characters found on a typical English language
keyboard) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot obtain
the SSID through scanning using a site survey tool.
Intra-BSS Traffic A Basic Service Set (BSS) exists when all communications between wireless clients or between a
wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled, wireless
clients can access the wired network and communicate with each other. When Intra-BSS is
disabled, wireless clients can still access the wired network but cannot communicate with each
other.
WMM QoS Check this to have the Zyxel Device automatically give a service a priority level according to
the ToS value in the IP header of packets it sends.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which
makes them run more smoothly.
Security Mode Select Static WEP , WPA-PSK , WPA , WPA2-PSK or WPA2 to add security on this wireless network.
The wireless clients which want to associate to this network must have same wireless security
settings as this device. After you select to use a security, additional options appears in this
screen. See
Section 7.3 on page 68 for detailed information on different security modes. Or you
can select No Security to allow any client to associate this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Apply Click Apply to save your changes.
Cancel Click Cancel to reload the previous configuration for this screen.