ZyXEL Communications IES4005M, Руководство пользователя

Страница: 106 / 236

Chapter 11 Management
IES4005M User’s Guide
106
11.10.2 Command Examples
This example allows computers in subnet 172.16.37.0/255 to access the IES through any service
except SNMP, allows the computer at 192.168.10.1 to access the IES only through SNMP, and
prevents other computers from accessing the IES at all.
no active
Disables the IPv4 trusted host entry. C 13
start-addr < ip-address > end-addr
< ip-address >
Configures a range of trusted hosts with the starting and ending
IPv4 IP addresses. Setting both the starting and ending addresses
to 0.0.0.0 removes the trusted host limitation. That is, any host
can access the IES. C 13
service <[icmp] [telnet] [ftp]
[snmp] [ssh]>
Allows the trusted host to access the IES through the specified
service(s). C 13
no service <[icmp] [telnet]
[ftp] [snmp] [ssh]>
Stops the trusted host from accessing the IES through the
specified service(s). C 13
show remote-management ipv6
Displays all IPv6 trusted host information. E 13
remote-management ipv6 < index >
Enters the sub-command mode for configuring the specified IPv6
trusted host entry. C 13
exit
Leaves the IPv6 trusted host configuration sub-command mode. C 13
active
Enables the IPv6 trusted host entry. C 13
no active
Disables the IPv6 trusted host entry. C 13
address < ipv6-address > mask
< mask >
Configures a trusted host with its IPv6 IP address and the prefix
length.
mask
: 0 ~ 128, 0 means any hosts.
C 13
service <[icmp] [telnet] [ftp]
[snmp] [ssh]>
Allows the trusted host to access the IES through the specified
service(s). C 13
no service <[icmp] [telnet]
[ftp] [snmp] [ssh]>
Stops the trusted host from accessing the IES through the
specified service(s). C 13
Table 73
remote management command summary (continued)
Command Description M P
ras# config
ras(config)# remote-management 1
ras(config-remote-management-1)# start-addr 172.16.37.0 end-addr
--> 172.16.37.255
ras(config-remote-management-1)# service icmp telnet ftp ssh
ras(config-remote-management-1)# exit
ras# config
ras(config)# remote-management 2
ras(config-remote-management-2)# start-addr 192.168.10.1 end-addr
--> 192.168.10.1
ras(config-remote-management-2)# service snmp
ras(config-remote-management-2)# exit
ras(config)# exit
ras#