ZyXEL Communications IES-1248-51A, Руководство пользователя

Страница: 269 / 654

Chapter 37 Access Control
IES-1248-51V User’s Guide
269
The following table describes the labels in this screen.
37.5 Service Access Control Screen
To open this screen, click Advanced Application > Access Control > Service
Access Control.
Figure 126 Service Access Control
Table 82 SNMP
LABEL DESCRIPTION
Return Click Return to go back to the previous screen.
Get Community Enter the get community, which is the password for the incoming Get-
and GetNext- requests from the management station.
Set Community Enter the set community, which is the password for incoming Set-
requests from the management station.
Trap Community Enter the trap community, which is the password sent with each trap
to the SNMP manager.
Trap Destination
1~4
Port
Enter the IP address of a station to send your SNMP traps to.
Enter the port number upon which the station listens for SNMP traps.
Trusted Host A “trusted host” is a computer that is allowed to use SNMP with the
IES-1248-51V.
0.0.0.0 allows any computer to use SNMP to access the IES-1248-
51V.
Specify an IP address to allow only the computer with that IP address
to use SNMP to access the IES-1248-51V.
Apply Click Apply to save your changes to the IES-1248-51V’s volatile
memory. The IES-1248-51V loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.