ZyXEL Communications IES-1248-51, Руководство пользователя

Страница: 354 / 385

IES-1248-51 User’s Guide
354 Chapter 50 Virtual Channel Management
50.7.8 RPVC Route Set Command
Syntax:
ras> adsl rpvc route set <port number> <vpi> <vci> <ip>/<netmask>
where
This command adds a domain for 2684 routed mode traffic. The domain includes the
subscriber’s LAN IP addresses.
Note: You must use the
rpvc gateway set
and the
rpvc set
commands before you
use the
rpvc route set
command.
The following example adds a domain for a CPE device is connected to DSL port 1 on the
IES-1248-51 and the 2684 routed mode traffic is to use the PVC identified by VPI 8 and VCI
35. The CPE device’s LAN IP address is 10.10.10.10 and uses a subnet mask of
255.255.255.0. This includes the CPE device’s LAN IP addresses and the IP addresses of the
LAN computers.
50.7.9 RPVC Route Show Command
Syntax:
ras> adsl rpvc route show <portlist>
<port number> =
The port of the RPVC. Specify a single ADSL port <1>.
<vpi> =
The VPI of the RPVC.
<vci> =
The VCI of the RPVC.
<ip> =
The subscriber’s CPE LAN IP address in dotted decimal
notation.
/<netmask> =
The bit number of the subnet mask of the subscriber’s IP
address. To find the bit number, convert the subnet mask to
binary and add all of the 1’s together. Take “255.255.255.0” for
example. 255 converts to eight 1’s in binary. There are three
255’s, so add three eights together and you get the bit number
(24).
Figure 247 RPVC Route Set Command Example
ras> adsl rpvc route set 1 8 35 10.10.10.1/24