ZyXEL Communications IES-1248-51, Руководство пользователя

Страница: 308 / 385

IES-1248-51 User’s Guide
308 Chapter 49 ADSL Commands
49.1.7 ADSL Profile Map Command
The
port set
command varies depending on your IES-1248-51 models.
Syntax:
ras> adsl profile map <portlist> <profile> <
glite|gdmt|t1413|auto|adsl2|adsl2+>
where
This command assigns a specific profile to an individual port and sets the port’s ADSL mode
(or standard). The profile defines the maximum and minimum upstream/downstream rates, the
target upstream/downstream signal noise margins, and the maximum and minimum upstream/
downstream acceptable noise margins of all the ADSL ports to which you assign the profile.
When set to auto, the port follows whatever mode is set on the other end of the line.
Note: When the mode is set to
auto
, the connection rates are governed by the
negotiated ADSL mode regardless of the rates configured in the profile. For
example, if the profile is set to use a rate of 18000 Kbps, that speed is only
supported if the negotiated ADSL mode is ADSL 2+. Any other ADSL mode will
limit the rate to what is supported by the specific ADSL standard.
The following example sets ADSL port 1 to have the gold profile in G.dmt mode.
49.1.8 ADSL Name Command
Syntax:
ras> adsl name <portlist> <name>
<portlist> =
You can specify a single ADSL port <1>, all ADSL ports <*>
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
<profile> =
The profile that will define the settings of this port.
<glite|gdmt|t14
13|auto|adsl2|a
dsl2+> =
The ADSL operational mode. Choose from
gdmt
,
glite
,
t1413
,
auto
,
adsl2
or
adsl2+
.
Figure 189 ADSL Profile Delete Command Example
ras> adsl profile map 1 gold gdmt