ZyXEL Communications GS-2724, Руководство пользователя

Страница: 59 / 348

GS-2724 User’s Guide
59
C
H A P T E R
5
Initial Setup Example
This chapter shows how to set up the Switch for an example network.
5.1 Overview
The following lists the configuration steps for the example network:
• Configure an IP interface
• Configure DHCP server settings
• Create a VLAN
• Set port VLAN ID
• Enable RIP
5.1.1 Configuring an IP Interface
On a layer-3 switch, an IP interface (also known as an IP routing domain) is not bound to a
physical port. The default IP address of the Switch is 192.168.1.1 with a subnet mask of
255.255.255.0.
In the example network, since the
RD network is already in the same IP interface as the
Switch, you don’t need to create an IP interface for it. However, if you want to have the Sales
network on a different routing domain, you need to create a new IP interface. This allows the
Switch to route traffic between the
RD and Sales networks.
Figure 20 Initial Setup Network Example: IP Interface
1 Connect your computer to the MGMT port that is used only for management. Make
sure your computer is in the same subnet as the MGMT port.