ZyXEL Communications EMG6765-Q10A, Руководство пользователя

Страница: 146 / 219

Chapter 21 Bandwidth Management
EMG6765-Q10A User’s Guide
146
21.4.1 Add/Edit a Queue
Click Add New Queue or the Edit icon in the Queue Setup screen to configure a queue.
Figure 83 Management > Bandwidth MGMT > Queue Setup: Add/Edit new queue
The following table describes the labels in this screen.
Rate Limit This shows the maximum transmission rate allowed for traffic on this queue.
Modify Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by one
when you take this action.
Table 63 Management > Bandwidth MGMT > Queue Setup (continued)
LABEL DESCRIPTION
Table 64 Management > Bandwidth MGMT > Queue Setup: Add/Edit new queue
LABEL DESCRIPTION
Active Select to enable or disable this queue.
Name Enter the descriptive name of this queue. Note that \"<>%\\^[]`\+\$\,='#&@.:() are not
allowed.
To Interface Select the interface to which this queue is applied.
Priority Select the priority level (from 1 to 7) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to higher priority queues
gets through faster while traffic in lower priority queues is dropped if the network is congested.
Weight Select the weight (from 1 to 8) of this queue.
If two queues have the same priority level, the EMG6765-Q10A divides the bandwidth across the
queues according to their weights. Queues with larger weights get more bandwidth than
queues with smaller weights.
Rate Limit Specify the maximum transmission rate (in Kbps) allowed for traffic on this queue.
Back Click this to return to the previous screen.
Apply Click this to save your changes.
Cancel Click this to exit this screen without saving.