ZyXEL Communications EMG6726-B10A, Руководство пользователя, Страница: 134 / 323

EMG6726/8726-B10A User’s Guide
134
C
H A P T E R
10
Quality of Service (QoS)
10.1 Overview
Quality of Service (QoS) refers to both a network’s ability to deliver data with minimum delay, and the
networking methods used to control the use of bandwidth. Without QoS, all traffic data is equally likely
to be dropped when the network is congested. This can cause a reduction in network performance and
make the network inadequate for time-critical application such as video-on-demand.
Configure QoS on the EMG to group and prioritize application traffic and fine-tune network
performance. Setting up QoS involves these steps:
1
Configure classifiers to sort traffic into different flows.
2
Assign priority and define actions to be performed for a classified traffic flow.
The EMG assigns each packet a priority and then queues the packet accordingly. Packets assigned a
high priority are processed more quickly than those with low priority if there is congestion, allowing time-
sensitive applications to flow more smoothly. Time-sensitive applications include both those that require
a low level of latency (delay) and a low level of jitter (variations in delay) such as Voice over IP (VoIP) or
Internet gaming, and those for which jitter alone is a problem such as Internet radio or streaming video.
This chapter contains information about configuring QoS and editing classifiers.
10.1.1 What You Can Do in this Chapter
• Use the General screen to enable or disable QoS and set the upstream bandwidth ( Section 10.3 on
page 136 ).
• Use the Queue Setup screen to configure QoS queue assignment ( Section 10.4 on page 137 ).
• Use the Classification Setup screen to add, edit or delete QoS classifiers ( Section 10.5 on page 140 ).
• Use the Shaper Setup screen to limit outgoing traffic transmission rate on the selected interface
( Section 10.6 on page 144 ).
• Use the Policer Setup screen to control incoming traffic transmission rate and bursts ( Section 10.7 on
page 145 ).
• Use the Monitor screen to view statistics of QoS on WAN/LAN interface and the status of queues
( Section 10.8 on page 147 ).