ZyXEL Communications EMG3425-Q10A, Руководство пользователя

Страница: 112 / 250

Chapter 14 Static Route
EMG3425-Q10A User’s Guide
112
Figure 65
Network > Static Route
The following table describes the labels in this screen.
14.2.1 Add/Edit Static Route
Click the Add Static Route button or a rule’s Edit icon in the Static Route screen. Use this screen
to configure the required information for a static route.
Figure 66
Network > Static Route: Add/Edit
Table 44
Network > Static Route
LABEL DESCRIPTION
Add Static Route Click this to create a new rule.
# This is the number of an individual static route.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Name This field displays a name to identify this rule.
Destination This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Interface This is the WAN interface through which the traffic is routed.
Modify Click the Edit icon to open a screen where you can modify an existing rule.
Click the Delete icon to remove a rule from the EMG3425-Q10A.
Apply Click Apply to save your changes back to the EMG3425-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.