ZyXEL Communications Broadband Security Gateway P-312, Руководство пользователя, Страница: 107 / 254

P312 Broadband Security Gateway
7-12 Filters
7.2.4 Generic Filter Rule
This section shows you how to configure a generic filter rule. The purpose of generic rules is to allow you
to filter non-IP packets. For IP, it is generally easier to use the IP rules directly.
For generic rules, the Prestige treats a packet as a byte stream as opposed to an IP or IPX packet. You
specify the portion of the packet to check with the Offset (from 0) and the Length fields, both in bytes. The
Prestige applies the Mask (bit-wise ANDing) to the data portion before comparing the result against the
Value to determine a match. The Mask and Value are specified in hexadecimal numbers. Note that it takes
two hexadecimal digits to represent a byte, so if the length is 4, the value in either field will take 8 digits,
e.g.,
FFFFFFFF
.
To configure a generic rule, select Generic Filter Rule in the Filter Type field in the Menu 21.4.1.1 and
press [ Enter] to open Generic Filter Rule, as shown below.
Figure 7-11 Menu 21.4.1.1 - Generic Filter Rule
Menu 21.4.1.1 - Generic Filter Rule
Filter #: 4,1
Filter Type= Generic Filter Rule
Active= No
Offset= 0
Length= 0
Mask= N/A
Value= N/A
More= No Log= None
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.