ZyXEL Communications ATP200, Руководство пользователя

Страница: 482 / 852

Chapter 25 Security Policy
ZyWALL ATP Series User’s Guide
482
25.5 Anomaly Detection and Prevention Overview
Anomaly Detection and Prevention (ADP) protects against anomalies based on violations of protocol
standards (RFCs – Requests for Comments) and abnormal flows such as port scans. This section
introduces ADP, anomaly profiles and applying an ADP profile to a traffic direction.
Traffic Anomalies
Traffic anomaly policies look for abnormal behavior or events such as port scanning, sweeping or
network flooding. They operate at OSI layer-2 and layer-3. Traffic anomaly policies may be updated
when you upload new firmware.
User This field is not available when you are configuring a to-Zyxel Device policy.
Select a user name or user group to which to apply the policy. The Security Policy is activated
only when the specified user logs into the system and the policy will be disabled when the user
logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified a source IP address (group) instead of any in the field below, the
user’s IP address should be within the IP address range.
Schedule Select a schedule that defines when the policy applies. Otherwise, select none and the policy is
always effective.
Action Use the drop-down list box to select what the Security Policy is to do with packets that match this
policy.
Select deny to silently discard the packets without sending a TCP reset packet or an ICMP
destination-unreachable message to the sender.
Select reject to discard the packets and send a TCP reset packet or an ICMP destination-
unreachable message to the sender.
Select allow to permit the passage of the packets.
Log matched
traffic Select whether to have the Zyxel Device generate a log ( log ), log and alert ( log alert ) or not ( no )
when the policy is matched to the criteria listed above..
Profile Use this section to apply anti- x profiles (created in the Configuration > Security Service screens)
to traffic that matches the criteria above. You must have created a profile first; otherwise none
displays.
Use Log to generate a log ( log ), log and alert ( log alert ) or not ( no ) for all traffic that matches
criteria in the profile.
Application
Patrol
Select an Application Patrol profile from the list box; none displays if no profiles have been
created in the Configuration > Security Service > App Patrol screen.
Content
Filter
Select a Content Filter profile from the list box; none displays if no profiles have been created in
the Configuration > Security Service > Content Filter screen.
SSL
Inspection
Select an SSL Inspection profile from the list box; none displays if no profiles have been created in
the Configuration > Security Service > SSL Inspection screen.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
Table 191 Configuration > Security Policy > Policy Control > Add (continued)
LABEL DESCRIPTION