ZyXEL Communications AMG1302-T11C, Руководство пользователя

Страница: 79 / 307

Chapter 6 Broadband
AMG1302-T11C User’s Guide
79
Encapsulation Select the method of encapsulation used by your ISP from the drop-down list box.
Choices vary depending on the mode you select in the
Mode field.
If you select Router in the Mode field, select PPPoA , IPoA , ENET ENCAP or PPPoE .
If you select Bridge in the Mode field, method of encapsulation is not available.
User Name (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your ISP assigned.
If assigned a name in the form user@domain
where domain identifies a service name,
then enter both components exactly as given.
Password (PPPoA and PPPoE encapsulation only) Enter the password associated with the user name
above.
Service Name (PPPoE only) Type the name of your PPPoE service here.
Multiplex Select the method of multiplexing used by your ISP from the drop-down list. Choices are
VC or LLC .
By prior agreement, a protocol is assigned a specific virtual circuit, for example, VC1 will
carry IP. If you select VC, specify separate VPI and VCI numbers for each protocol.
For LLC-based multiplexing or PPP encapsulation, one VC carries multiple protocols with
protocol identifying information being contained in each packet header. In this case, only
one set of VPI and VCI numbers need be specified for all protocols.
IPv6/IPv4 Dual
Stack Select IPv4 if you want the AMG1302-T11C to run IPv4 only.
Select IPv4/IPv6 to allow the AMG1302-T11C to run IPv4 and IPv6 at the same time.
Select IPv6 if you want the AMG1302-T11C to run IPv6 only.
This field is not available when you select IPoA in the Encapsulation field.
PPP
Authentication The AMG1302-T11C supports PAP (Password Authentication Protocol) and CHAP
(Challenge Handshake Authentication Protocol). CHAP is more secure than PAP; however,
PAP is readily available on more platforms.
Use the drop-down list box to select an authentication protocol for outgoing calls. Options
are:
AUTO - Your AMG1302-T11C accepts either CHAP or PAP when requested by this remote
node.
CHAP - Your AMG1302-T11C accepts CHAP only.
PAP - Your AMG1302-T11C accepts PAP only.
VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management of
ATM traffic). Enter the VCI assigned to you.
IP Address This option is available if you select Router in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed;
the ISP assigns you a different one each time you connect to the Internet.
Select Obtain an IP Address Automatically if you have a dynamic IP address;
otherwise select Static IP Address and type your ISP assigned IP address in the IP
Address field and a gateway IP address (supplied by your ISP) below.
IP Address Enter the IP address assigned by your ISP.
Gateway IP
Address
Specify a gateway IP address (supplied by your ISP).
Primary DNS Enter the primary DNS server’s address for the AMG1302-T11C.
Secondary
DNS
Enter the secondary DNS server’s address for the AMG1302-T11C.
Table 14
Network Setting > Broadband > More Connections: Edit (continued)
LABEL DESCRIPTION