ZyXEL Communications AMG1302-T11C, Руководство пользователя

Страница: 76 / 307

Chapter 6 Broadband
AMG1302-T11C User’s Guide
76
6.3 The More Connections Screen
The AMG1302-T11C allows you to configure more than one Internet access connection. To configure
additional Internet access connections click
Network Setting > Broadband > More
Connections . The screen differs by the encapsulation you select. When you use the Broadband >
Internet Connection screen to set up Internet access, you are configuring the first WAN
connection.
Note: This screen is not available if you set the Line Type to Ethernet(ETH1) in the
Internet Connection screen.
Figure 22
Network Setting > Broadband > More Connections
The following table describes the labels in this screen.
Maximum Burst
Size
Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at
the peak rate. Type the MBS, which is less than 65535.
PPPoE Passthrough If encapsulation type is PPPoE, select this to enable PPPoE Passthrough. In addition to
the Device’s built-in PPPoE client, you can select this to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP via the device. Each
host can have a separate account and a public WAN IP address.
MTU
MTU The Maximum Transmission Unit (MTU) defines the size of the largest packet allowed
on an interface or connection. Enter the MTU in this field.
For ENET ENCAP, the MTU value is 1500.
For PPPoE, the MTU value is 1492.
For PPPoA and RFC 1483, the MTU is 65535.
Table 12
Network Setting > Broadband > Internet Connection: Advanced Setup (continued)
LABEL DESCRIPTION
Table 13
Network Setting > Broadband > More Connections
LABEL DESCRIPTION
ADSL Connections Table
# This is an index number indicating the number of the corresponding connection.