Chapter 1 Introduction
AMG1302-T11C User’s Guide
16
1.6 Using the WPS Button
You can also use the
WPS
button to quickly set up a secure wireless connection between the
AMG1302-T11C and a WPS-compatible client by adding one device at a time.
To activate WPS:
1
Make sure the
POWER
LED is on and not blinking.
2
Press the
WPS
button for 1-5 seconds and release it. See below for WPS button location.
3
Press the WPS button on another WPS-enabled device within range of the AMG1302-T11C. The
WPS
LED should flash while the AMG1302-T11C sets up a WPS connection with the other wireless
device.
4
Once the connection is successfully made, the
WPS
LED becomes static green and turns off after
two minutes.
1.7 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the
RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the user name and password will be reset to
the default.
WPS
Содержание AMG1302-T11C
