ZyXEL Communications AAM1212-51, Руководство пользователя

Страница: 392 / 435

AAM1212-51/53 Series User’s Guide
392 Chapter 53 Virtual Channel Management
• In general deployment, the computer must set the CPE device’s LAN IP address
(10.10.10.10 in this example) as its default gateway.
• The subnet range of any RPVC and RPVC domain must be unique.
Use the following command sequence to configure the AAM1212 for this example set up.
53.7.2 RPVC Gateway Set Command
Syntax:
ras> adsl rpvc gateway set <gateway ip> <vlan id> [<priority>]
where
This command adds a gateway IP address to use for 2684 routed mode traffic.
The following example has the device use a VLAN ID of 1 and IEEE 802.1p priority of 3
when sending 2684 routed mode traffic to a gateway at IP address 192.168.10.102.
53.7.3 RPVC Gateway Show Command
Syntax:
ras> adsl rpvc gateway show
This command displays
the gateway IP addresses that are configured for use with 2684
routed mode traffic.
Figure 272 2684 Routed Mode Commands Example
ras> adsl rpvc gateway set 192.168.10.102 1
ras> adsl rpvc set 1 8 35 DEFVAL 192.168.10.200/32 192.168.10.102
ras> adsl rpvc route set 1 8 35 10.10.10.1/24
<gateway ip> =
The IP address of the gateway to which you want to send the
traffic that the system receives from this PVC. Enter the IP
address in dotted decimal notation.
<vlan id> =
The VLAN Identifier to add to Ethernet frames that the system
routes to this gateway.
[<priority>] =
Set the IEEE 802.1p priority (0~7) to add to the traffic that you
send to this gateway.
Figure 273 RPVC Gateway Set Command Example
ras> adsl rpvc gateway set 192.168.10.102 1 3