ZyXEL Communications AAM1212-51, Руководство пользователя

Страница: 236 / 435

AAM1212-51/53 Series User’s Guide
236 Chapter 36 Alarm
36.5 Alarm Port Setup Screen
Use this screen to set the alarm severity threshold for recording alarms on an individual
port(s). The system reports an alarm on a port if the alarm has a severity equal to or higher
than the port’s threshold.
To open this screen, click Alarm , Alarm Port Setup .
Figure 124 Alarm Port Setup
The following table describes the labels in this screen.
Severity Select an alarm severity level (critical, major, minor or info) for this alarm. Critical
alarms are the most severe, major alarms are the second most severe, minor
alarms are the third most severe and info alarms are the least severe.
Clearable Select this check box to allow administrators to use the management interface to
remove an alarm report generated by this alarm event entry.
Select this check box to keep an alarm report generated by this alarm event in
the system until the conditions that caused the alarm report are no longer
present.
Apply Click Apply to save your changes to the AAM1212’s volatile memory. The
AAM1212 loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Close Click Close to exit the screen without saving your changes.
Table 83 Alarm Event Setup Edit (continued)
LABEL DESCRIPTION
Table 84 Alarm Port Setup
LABEL DESCRIPTION
Alarm Status Click Alarm Status to go to a screen that displays the alarms that are currently
in the system (see Section 36.2 on page 231 ).
Alarm Event Setup Click Alarm Event Setup to go to a screen where you can configure the severity
level of an alarm(s) and where the system is to send the alarm(s). See Section
36.4 on page 233 .