Zünd L-1200, Руководство по эксплуатации

Страница: 116 / 142

Cleaning and maintenance PN series frame version
Maintenance jobs
6-8
110010,001,11-2009, jmu
6
6.5 Maintenance jobs
6.5.1 Maintenance position
Warning !
Danger of injury
The cutter may be put into operation by third parties.
•
Always place the cutter in the maintenance position before carrying out mainte
-
nance work!
Unless expressly required otherwise, move the machine to the maintenance position
before starting maintenance work.
– Switch off the machine using the main switch.
– Protect the machine from unauthorised commissioning
6.5.2 Visually inspect machine for damage
Attention !
There is a risk of injury if the machine is damaged
Before daily commissioning ensure that there is no damage to the machine.
•
Never start up a damaged machine.
• Have damage repaired immediately by authorised service personnel
Daily checks
•
Walk around the cutter and check the machine for damage.
• Make sure that all the covers have been fitted. Fit any covers that are missing.
6.5.3 Clean the machine
Zünd cutters are production machines that are subject to enormous amounts of
stress on a daily basis. Keeping the machine clean will help to keep operation as free
from interruption as possible.
Important !
Do not use compressed air to clean the machine.
Loose cuttings and other dirt will end up in the bearings and drive belts and damage
them.
Attention !
Danger of damage
Incorrect cleaning products and methods will damage the machine
•
Only use gentle cleaning agents and plastic maintenance products for cleaning.
• Never clean the tool using ultrasound, a steam jet, compressed air etc.
Procedure
•
Clean the table, operating unit, all covers and panels with a plastic maintenance
product at regular intervals (weekly).