MG Series Gateway Setup Manual ver 306.X (0000000272)
Revision 20 Jul. 12, 11
© 2011 Zultys, Inc. No reproduction of distribution without permission
Page 38 of 42
Technical
Publications
12
S IP protocol S ettings
SIP protocol Settings are on the Basic tab and click on the
SIP
link.
12.1
You need to s et up three parameters on the S IP Configuration
page.
Recommended Settings:
S ignaling port:
5060
Regis trar s erv er:
IP Address or FQDN of the MX:5060
Prox y S erv er:
IP Address or FQDN of the MX:5060
Authentication mode:
Register by line
Regis tration period:
3600
Name
Des cription
S ignaling port
Configure the UDP port for transmitting and receiving SIP messages,
with its default value 5060.
Note: The signaling port number can be set in the range of 1-9999,
but cannot conflict with the other port numbers used by the
equipment.
Regis ter s erv er
Configure the address and port number of SIP register server, and
value.
The register server address can be an IP address or a domain name.
When a domain name is used, it is required to activate DNS service
and configure DNS server parameters on the page of configuring
