9
3. APPLICATION INSTRUCTION
3.1 REMOTE CONTROLLER
Keys Instruction and Application
：
Finishing initialization, it can receive and execute the IR
commands. Press the remote controller button, the
indicator light is flashing; release the button, the indicator
light stops flashing. Users can control the pan/ tilt/ zoom,
setting and running preset positions via remote
controller.
Key Instruction:
1. In the below instruction, “press the key” means a
click rather than a long press. A special note will be
given if a long press for more than one second is
required.
2. When a key combination is required, do it in
sequence. For example, [*] + [#] + [F1] means press [*]
first, then press [#] and finally press [F1].
1. Standby Key
After 3s long press, the camera will step into standby
mode. Long press 3s again, the camera will self-check
again and back to HOME position.
Note: If power-on mode is turned on and Preset 0 is set,
it will automatically point to the specified preset
position when there is no operation within 12s.
2. Camera Address Selection
Select the camera address to control.
3. Number Key
Set or run 0-9 presets.
Press a number key 0-9 directly to run a relative preset.
Note: Action in vain if a relative preset position is not
existed.
4. */ # Key
Key combination use
5. Focus Control Key
Auto Focus: Enter into auto focus mode.
Manual Focus: Enter into manual focus mode. Switch
the camera focus mode to manual focus by pressing [+]
or [-] to adjust.
Focus(near): Press [+] key (Valid only in manual focus
mode)
Focus(far): Press [-] key (Valid only in manual focus
mode)
Press and hold the key, the action of focus will keep
continue and stops as soon as the key is released.
6. Zoom Control Key
Zoom
＋
: Lens near (Zoom in)
Zoom
－
: Lens far (Zoom out)
Press and hold the key, the camera will keep zooming
in or out and stops as soon as the key is released.
