A: Foreword:
1. Please read this manual carefully before
installation and operation.
2. Please pay attention to the warnings,
cautions and safety guidelines.
3. Please keep this manual.
4. To get best effect, please choose different
distance, heating time and procedure
according to different paint, operation
condition and actual natural condition.
B: Features:
One mechanical timer: 0-60 minute timing.
Automatic timed shut-off: reduces the
chance of paint finish damage due to
overheating.
Independent lamp switch.
Powerful heat penetration directly into inner
paint layers to accelerate molecular
reaction of paint. Super fast drying for
polyurethane
paint
(double-component
paint) for limousine, single-component
coating and water-based paint.
Durable IR bulb (emitter).
High-light,
wide-angle,
fully
focused
reflector. Uniform, focused cure area: no
hot or cold spots.
Cassette can rotate 360 degrees.
"slide and lock" bracket.
Bolt through column: no danger of dropping
to ground.
Replaceable lamp bulb. Removable grill.
Cleanable, solvent-resistant reflector.
Strong, durable column (stainless) and
pedestal construction.
C: Warranty:
One year from the date of purchase
D: Specifications:
◇
Input voltage: 220-240V 50HZ
（
1PH
）
◇
IR lamp bulbs: 2×1050W
◇
Max power: 2150W
◇
Rated input current: 12A
◇
Covering area : 0.6M×0.8M
◇
Timing range: 0-60MIN
◇
Timer operation: By knob
◇
Temperature: 60
℃
--70
℃
◇
Recommended curing distance: 30-50cm
(please adjust it according to
actual
conditions)
E: Safety instructions:
1.
Do not modify or neutralize safety
elements;
2.
Do not modify the technical specifications
of the product.
3.
Often clean reflector and lamp bulb with
moistened fabric or cotton and keep them
clean. Do not use this equipment until 20
minutes after cleaning; otherwise,
lamp bulb will be broken easily.
4.
This product must be earthed.
5.
Do not use this product in a spray booth
where there may be flammable gas.
6.
Air must be decontaminated for working
area if this product is used in spray booth.
7.
It must be protected with a 10 AMP fuse.
8.
Isolate power supply before removing
covers.
9.
DO NOT move this machine during
operation as this may lead to premature
lamp failure.
10. This machine must not be pointed at
personnel or easily flammable objects.
11. Do not bump or knock this product.
12. Avoid hard objects to get inside of cassette.
13. Pay attention to uneven floor when moving
this product and avoid overturning it.
14. Remove packing pieces from cassette
before use.
15. Remove all things in front of lamp lamp bulb
before turn on it.
16. Keeps lamp away from paint spraying area
at least 4 meters before starting this
equipment.
17. Do not hold mains cable to move this
product.
18. If lamp doesn’t work when turn on this
product,
connector
of
lamp
maybe
loosened. Turn off power and connect lamp
again.
F: Suggested drying time
(Minutes. For reference only. You may adjust it
according to actual conditions):
Paint type
Time
Waterborne basecoat
7-10
Filler/Stopper
7-12
Primer
8-13
Waterborne primer
10-15
Hi-build
12-17
Solid-color
13-16
Clear coat
14-17
Manual for Shortwave Infrared Paint Dryer
K2251
ZOVCAND ELECTRIC APPLIANCE CO., LTD || www.zovcand.com
