Zontes ZT350T-D, Руководство по обслуживанию

Страница: 44 / 152

44 / 152
Radiator
●The vehicle must be parked on a flat and stable ground or a
lifting platform.
●Once the engine and muffler have cooled down, the
operation can be performed.
●Swallowing or inhaling the coolant will cause harm to the
human body.
●Regularly check the coolant level, and always keep the
position not lower than the "L" line.
●It is recommended to replace the coolant every 4 years or
40,000 kilometers (24855 mile).
●Swallowing or inhaling the coolant will cause certain harm
to the human body. After each addition of coolant, wash
hands, face and any exposed skin thoroughly in time. If
swallowed by mistake, immediately contact the poison
control center or hospital; if inhaled, immediately go to a
ventilated environment. If it accidentally splashes into the
eyes, immediately rinse the eyes with a large amount of
running water and seek medical advice or consultation in
time. Keep away from children and pets.
●The engine coolant must be a model suitable for aluminum
radiators, based on ethylene glycol. Use a coolant that is
suitable for aluminum radiators, which is a mixture of
coolant concentrate and distilled water in a certain
proportion. If you need to add water, you can only add
distilled water. Other water quality may corrode the engine
cooling system or cause more serious consequences.
●It is necessary to select the corresponding antifreeze liquid
according to the lowest possible local temperature. The
vehicle added to the factory is Total -35°C (-31F) green
antifreeze. M310 the total amount of coolant is 1.44L (1.52
US qt, 1.27 lmp qt, 0.38 US gal, 0.32 lmp gal).
●Coolant may damage the paint surface. Pay attention when
adding it. A small amount of splash should be wiped off with
a clean soft cloth immediately.
1. D350 check the coolant
a. Straighten the vehicle through the right rear gap and
use a flashlight to check that the coolant level is between "H"
and "L". Pay attention to the ground as flat and level as
possible, do not check on slopes. And the engine needs to be
in a cold state.
2. D350 add coolant (antifreeze) to the Coolant
expansion tank
If the water level of the Coolant expansion tank is lower
than the "L" line, an appropriate amount of coolant must be
added. If there is no coolant in the Coolant expansion tank,
check the cooling system for leakage first, and it must be
repaired before it can be replenished.
a. Use 4# Allen to remove the M6×14 shoulder bolt (1) and
expansion nail of the right foot bracket after the right cover
is connected; Grasp the mark of the right lid (green
rectangle) with your hand, and pull it out alternately from
the outside to the inside in the direction of the small arrow,
until all 5 mushroom buckles (red circles) on the left lid are
pulled out, and remove the left cover.
b. Lift the rubber cover of the auxiliary tank and add an
appropriate amount of coolant to it with the help of the
funnel. Straighten the vehicle with a flashlight to see if the
liquid level of the auxiliary tank is between "H" and "L". Pay
attention to the ground as flat and level as possible, do not
check on slopes. And the engine needs to be in a cold state.
3. D350 add coolant to the Radiator
a. Turn the fork to the bottom to the right and add coolant
by unscrewing the main tank filler cap counterclockwise.
b. Use a 10# sleeve to loosen the thermostat bleed bolt
⑵
counterclockwise by 4 to 5 turns, do not completely remove
it. Note that a small container is required to receive the
coolant overflowing from the exhaust bolt. Do not allow the
coolant to drip directly onto the surface of the part.