Zontes ZT310T-M, Руководство по обслуживанию

Страница: 58 / 184

58
/
184
2.4 Assembly
Caution:
●Before assembling, it is necessary to conduct a
comprehensive inspection of all the parts of the
disassembled continuously variable clutch sub-
assembly, and replace the parts that reach the limit of
use.
●Use compressed air to completely clean the dust
accumulated in the left crankcase belt chamber before
assembling.
●Before assembling, it must be ensured that there is no
oil stain on the driving wheel, V-belt, and driven wheel to
avoid slipping failure after assembling.
a. First install the φ23.2×φ40×3.25 washer on the
crankshaft and assemble it in place.
b. Then check whether the 8 Puli beads are
completely placed in the Puli groove of the driving wheel
sliding disk (Figure 1 below), and then assemble the
slope plate with the four guide blocks corresponding to
the position of the driving wheel sliding disk guide post
on the driving wheel. The wheel slides on the disc
(picture 3 below).
Caution: The covered end of the inner hole of the
Puli bead points to the counterclockwise rotation
direction. Otherwise, it is easy to cause the failure of
the embedded steel sleeve of Pulizhu to fall off when
the engine is running! ! !
c. Turn over the driving wheel slide plate with Puli
beads and ramp plate as a whole, and then install the
distance tube into the inner hole of the driving wheel
slide plate. Then squeeze the sliding plate and the ramp
plate with one hand (to prevent the spread of the Puli
beads from falling), and hold the exposed distance tube
with the other hand to align the inner hole of the
distance tube with the crankshaft, and then slide the
ramp plate, pull beads, and slide The combination of the
disc and the fixed distance cylinder is assembled as a
whole to withstand the φ23.2×φ40×3.25 washer.
d. Place the driven wheel flat on a workbench or a
clean ground, then make the indicating arrow on the V-
shaped drive belt point to the counterclockwise rotation
direction, place the V-shaped drive belt on the outer ring
of the driven wheel, and make a certain distance The
driven wheel is 4
～
5cm away. The palms of both hands
partially press the clutch cover of the driven wheel, and
the fingers of both hands buckle the moving plate of the
driven wheel while pulling it upwards while rotating it