Zontes ZT310T-M, Руководство по обслуживанию

Страница: 40 / 184

40 / 184
draw it out or add it to the standard.
Throttle valve body
Caution:
●The three -in-one sensor and stepper motor cannot be
immersed in any liquid.
●It is forbidden to adjust the idle speed adjustment
screw on the valve body.
1. Do not dismantle the throttle body to clean up
carbon deposits
a. In the process of riding, without affecting safety and
complying with traffic laws, appropriately increase the
throttle to increase the speed to more than 7000 and
continue riding for no less than 2 minutes. High-speed
scavenging can effectively remove carbon deposits.
b. Use a regular and qualified fuel cleaner to add in
the amount indicated. Frequent use may cause damage
to the oil supply line.
2. Remove the stepper motor and clean up carbon
deposits
a. After opening the seat cushion, use 10# gun head +
ratchet wrench to remove 3 nuts
⑴
. Remove the seat
cushion and put it away. Be careful not to put it directly
on the ground and avoid scratching the cushion skin.
b. Use 4# inner hexagon to press down 4 expansion
nails
⑵
center cylindrical pins, and then a total of 4
expansion nails on the left and right sides
⑵
.
c. Grasp the rear of the battery cover assembly, turn it
up, and then pull it out toward the rear of the vehicle.
Note that there are buckles on both sides of the front.
The rebate position needs to be inserted in the front
when re-installing.
d. Open the black negative protection cap of the main
wiring harness, use a cross-battery or 10# sleeve to
remove the battery's own bolts and move the negative
line away from the battery; then open the red positive
protection cap and remove the positive bolts. Remove
the positive wire. Remove the battery upwards.
Folding rear storage box:
Monolithic rear storage box:
Folding rear storage box vehicles should follow steps
e to g, and the monolithic rear storage box go directly to
step h.
e. Pull up the 3 fuse boxes and pull out the cables.
When re-installing, you need to insert the fuse box back
to the corresponding position and arrange all the cables,
otherwise it will be difficult to fit the battery cover in
place.