Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 171 / 218

171
/
218
pull it out from the lower part of the direction cover, and
then pull it out from the hose bracket. Check whether the
surface of the removed hose is aging, cracked, damaged,
abraded, etc. Wipe up the remaining brake fluid with a non-
woven cloth, and then wrap the ends of the hose with cling
film or a plastic bag to prevent foreign matter from entering.
Remove and inspect the RMC-HU hose in the same way.
FC-HU and wheel speed sensor (front wheel)
a. Locate the plug of the wheel speed sensor on the left
side of the frame, and pull out the plug after pressing the
anti-release card.
b. For the removal method of FC-HU and wheel speed
sensor caliper, please refer to the section “Removing the
front disc brake caliper”.
c. Cut off the 2 cable ties ⑴ , remove the 3 wire ties ⑺ , and
remove the wheel speed sensor wire ⑹ . Check whether the
cable is damaged. If the cable sheath is frayed, wrap it with
electrical tape to avoid short-circuit and cause vehicle failure.
The front wheel speed sensor is also responsible for
providing a speed signal to the meter to display the speed
per hour.
Use an 8# sleeve to remove the bolt ⑵ , and take off the
FC-HU hose.
If you need to remove the hose bracket ⑷ , you can use 4#
inner hexagon to remove the bolt ⑶ and then take it off. If
you only remove the hose, you can skip this step.
d. Check whether the surface of the removed hose is
aging, cracked, damaged, abraded, etc. Wipe up the
remaining brake fluid with a non-woven cloth, and then wrap
the ends of the hose with cling film or a plastic bag to
prevent foreign matter from entering. Check whether the
cable sheath of the wheel speed sensor cable is damaged. If
the sheath is frayed, it can be glued with electrical tape to
prevent short-circuit.
RC-HU and wheel speed sensor (rear wheel)
a. Find 3 cable ties on the frame tube above the fuel tank
on the right side of the frame, and cut the cable ties ⑴ that
bind the RC-HU hose in the middle. Do not cut the other 2
cables. When reinstalling, make sure that the cable tie
cannot be tied too tightly, and a certain gap should be left.
b. Find the plug of the wheel speed sensor ⑵ on the right
side of the middle part and unplug it.
c. First remove the 3 pieces of wire clamp ⑷ , and then pull
out the wheel speed sensor ⑵ and the RC-HU hose from the
4 pieces of oil pipe clamp
⑶
. If you need to remove the
tubing clamp (3), you can use 4# inner hexagon to remove
the bolts and then you can take it off.
d. Pull the RC-HU head out of the gap between the
auxiliary water tank and the frame.