SETUP INSTRUCTIONS
Su
b
Zone
Stand-Alone Modulating Damper
Controlled with Auto Changeover
Programmable Wireless Thermostat
W I R E L E S S T H E R M O S T A T
BATTERY INSTALLATION/REPLACEMENT
The SubZone Wireless Thermostat requires two AA batteries. When the battery ICON on SubZone wireless controller
indicates batteries are low, replacement of batteries is required. To access batteries, locate SubZone Wireless Thermostat set
screw on the bottom of the thermostat. Turn screw clockwise - this will cause the screw to move into stat sub-base. Once set
screw is free of SubZone stat, remove stat from sub-base. Remove batteries from the back of thermostat and insert
replacement batteries; insuring positive and negative poles match battery to thermostat. Place thermostat on sub-base and
turn set screw counter clockwise to fasten thermostat to sub-base. Reset time on the SubZone after battery replacement.
MOUNTING THE SUBZONE
Once you have determined where you want to place the
thermostat place the mounting plate in that spot and with
a pencil mark where the drill holes will be. Drill holes
using a 1/8 drill bit. Install screw anchors supplied with
the thermostat. Install the screws into the screw anchors
half way and place the mounting plate over the screws.
Once the mounting plate is level tighten the screws down
to secure the plate to the wall. Install the thermostat back
on the mounting plate and turn the Allen screw CCW to
secure the thermostat back to the plate.
With a 5/64 Allen wrench unscrew CW to release
the thermostat from the mounting plate.
BOTTOM
+
+
+
+
+
+
_
_
_
AA
AA
+
_
Replace with AA batteries and install the
thermostat back on the mounting plate.
MOUNTING PLATE
Drill hole here
Drill hole here
