4/10/2019
V4 User Manual and Installation Guide – Zonar Systems Support
https://support.zonarsystems.net/hc/en-us/articles/360017847851-V4-User-Manual-and-Installation-Guide
16/27
CAUTION: Zonar has approved two types of fuse taps. Use of other brands is not authorized. Do not install these
fuse kits in fuse panel locations greater than 10 amps.
LitteFuse brand: Add-a-Circuit
Bussman brand: Add-a-Fuse
Poke and Weave Installation
Whenever it is not possible to use Add-a-Circuit fuse taps then the poke and weave method must be used.
1. Locate the proper wire where the poke and weave method is to be installed. Strip 3/4” to 1” of insulation from the
wire in the vehicle to be installed. Spread the wire strands apart as shown below.
2. Strip 1” to 1 1/2” of insulation from the wire in the fused link to be installed.
3. Insert the wire from the fused link into the spread wire in the vehicle. Wrap around the wire several times.
