ZOLL IVTM, Руководство по эксплуатации

Страница: 88 / 110

80
Figure 4.78. Installed HMIA – Rear Display Head
10. Select the appropriate custom ZOLL interface cable that mates with the patient cable of the hospital
monitor.
11. Insert the phone jack of the selected cable into the HMIA connector labeled T1 out.
12. Connect the other end of the ZOLL interface cable to the patient cable of the hospital monitor.
13. Prepare the hospital monitor such that it will monitor patient temperature.
14. Power ON the console.
15. Verify that the Green LED of the HMIA is ON.
16. Connect a TP-400 temperature simulator to the T1 connection on the front of the console. Set to 35ºC.
17. Using an air trap test fixture to complete the set-up procedure, place the console in Standby.
18. Verify that the patient temperature displayed by the console is also displayed on the hospital m/-
0.1ºC.
Note. There may be a delay, as long as 2 minutes, before the temperature displayed by the hospital mon-
itor agrees, /- 0.1ºC, with the temperature displayed by the console.
19. Set the TP-400 to 38ºC.
20. Verify that the patient temperature displayed on the console screen is also displayed on the hospital
m/- 0.1
O
C.
21. Remove the TP-400 and verify that the hospital monitor recognizes the loss of patient temperature.
Typically the hospital monitor will indicate that the probe is disconnected.
22. Reconnect the TP-400
23. Verify that the patient temperature shown on the display screen is also displayed on the hospital monitor
+/- 0.1ºC.
24. Power off the console.
25. Verify that the hospital monitor recognizes the lack of input. Typically the hospital monitor will indicate
that the probe is dislodged.
26. The console with the HMIA module is now available for clinical use.
Removal of the HMIA
To remove the HMIA, simply apply the installation instructions in reverse beginning with step 12.