ZOLL AutoPulse NXT, Руководство пользователя

Страница: 34 / 85

Chapter 6. Battery Charger
AutoPulse NXT User Guide 29
Setting up the battery charger
To prepare the battery charger for use:
1. Make sure the circuit breaker on the back of the battery charger is on and remains on. Do not turn off.
2. Plug the power cord into the power port on the back of the battery charger.
3. Plug the power cord into a wall electrical outlet.
When the battery charger is first plugged in, all indicators on the battery charger’s control panel illuminate
briefly and the power indicator remains illuminated. See “Battery charger panel” on page
31.
Note. If the indicators do not illuminate, check the power cord and circuit breaker. If the battery charger
alert indicator illuminates, see Table B.2, “Battery charger troubleshooting,” on page 66 . If all indicators
remain illuminated, contact "Technical Support" (page 60 ).
To remove power from the battery charger, unplug the power cord from the wall electrical outlet. For the
lock i ng power cord, press the red button before unplugging.
Using the battery charger
To maximize battery capacity and life, charge at operating temperatures (Table C.5 on page 70 ). If possible,
charge the battery at room temperature [10ºC (50ºF) to 30ºC (86º)F]. For optimal charging, the battery should
be at room temperature before inserting into the battery charger. If the battery's internal temperature is out of
range (Table
C.5 on page 70 ), the battery does not charge. The status indicator on the battery charger blinks
very slowly until the battery is within the temperature range.
2 Power port
3 Potential equalization port
4 Ethernet port
Number Description