ZOLL AutoPulse 100, Руководство пользователя

Страница: 57 / 88

Page
3-19
User Guide
From any of the information displays, press the gray Menu/Mode Switch button under the word “back”
to return to the main Menu or Administrative Menu.
To exit from the menu, press the gray Menu/Mode Switch button under the word “back.” The Platform
returns to the idle state, ready for patient alignment.
To exit from the Administrative Menu, press the “START” (green) button under the word “RESTART.”
The Platform will restart and place you into the idle state, ready for patient alignment.
3.8 Uploading Platform Information to your PC
The Platform has an infrared communication port located on the top (“head”) edge of the unit just below
the On/Off button (see Figure 3-1). This port is provided to allow upload of the information from the
platform. Currently the platform will upload the patient information from at least the last three patient
sessions (and potentially many more depending on the length of the resuscitation efforts). The uploaded
patient information consists of the key timing information on the Platform use.
Prior to using the Platform infrared communication port, the Code Review software must be installed on
your host computer. This software may be acquired from ZOLL Data Systems (www.zolldata.com) or
from your ZOLL Data Systems representative (+1.978.421.9655). Installation instructions, the
software's User Guide and system requirements are provided with the software. The computer with Code
Review installed must be equipped with an infrared communication adapter listed below.
• iFoundry InfraRed Communication Module (serial port 8001A or USB port 8003A)
• Actisys InfraRed Communication Module
To purchase an infrared adaptor, please contact ZOLL.