11
© 2020. All rights reserved.
Z Control LED and
Alarm Behaviors
Power LED
Power LED is on when AC power is present.
Alarm
Input LED on solid.
Alarm triple beeps continuously.
Z Control LED
LED is solid when connected to router and Basement Sentry app.
LED is off when STBS700 controller is in AP mode.*
LED blinks when WIFI setup is in process.
LED blinks faster if STBS700 controller is attempting to reconnect to a
known router.
LED alternates blinking fast then slow when STBS700 controller is
connected to router, but internet is lost.
Silence Button
Press/release
Silences alarms. LED that is in alarm stays on (or blinks) until
STBS700 controller is reset.
Hold 3 seconds
Resets any active alarms and returns STBS700 controller to standby
mode.
Hold 4 seconds
Initiates an LED and Alarm Test. Will flash and double beep 3 times.
Hold while applying AC to
STBS700 controller
STBS700 controller will enter AP mode.* For STBS700 controller to
revert to previous WIFI settings, power cycle again.
Hold 12 seconds
Complete reset of STBS700 controller to factory settings, including
erasing WIFI settings. STBS700 controller will enter AP mode.*
Communications
Communication with
Basement Sentry app
Communication is nearly continuous.
Communication with
Basement Sentry app lost
Notification sent to user after 10 minutes of no communication.
Alarm condition present
Immediate communication to Basement Sentry app.
STBS700 PUMP LED, BUTTON, ALARM, AND CONTROLLER BEHAVIORS
Product information presented here reflects conditions at time of publication. Consult factory regarding discrepancies or inconsistencies.
