QUICK REFERENCE GUIDE.
SEE INSTRUCTION MANUAL FOR COMPLETE
DETAILS.
DRAIN PUMP
SYSTEM
MODEL #1104-0082
Thread 2-in slip coupling into the vent
opening on the top of the basin.
Thread 1-1/2-in slip coupling into the
discharge opening at the top of the basin.
Attach rigid 2-in vent pipe to the 2-in slip
coupling according to local, regional, and
state codes.
Attach rigid 1-1/2-in discharge pipe to
the 1-1/2-in slip coupling, and plumb
into existing drain pipe according to local,
regional,a and state codes. Use check valve
as required.
Thread compression fitting into opening on
the side of the basin. Insert drain pipe into
1-1/4-in slip coupling. Insert drain pipe
into the inlet opening on the side of the
basin and tighten fitting.
Connect power cord to GFCI outlet.
Fill the basin with water to check operation.
The pump will start when the water level
has activated the float switch.
Vent
Opening
Discharge
Opening
Discharge Pipe
Vent Pipe
Inlet Pipe
On Level
Zoeller
®
is a registered trademark of Zoeller Co. All Rights Reserved.
025180 A
1
2
3
4
5
6
7
• Always disconnect power source
before attempting to install,
service or maintain the pump.
• Never handle a pump with wet
hands or when standing on wet
or damp surface or in water.
Fatal electrical shock could
occur.
• This pump is not designed for
pumping effluent or sewage.
• Pump only clear water. Do not
pump flammable or explosive
fluids such as gasoline, fuel oil,
kerosene, etc. Do not use in
a flammable and/or explosive
atmosphere. Failure to follow
these warnings could result in
death or serious injury and/or
property damage.
