4
2.3 Installation Diagram
Installation of the pH Perfect on the filtration system:
It is recommended that pH Perfect be installed after the filter (and any heating
device) but before the salt chlorinator cell... if no salt chlorinator is installed it
should be the last device on the return line
Hydraulic Diagram
Your pH sensor is a very delicate product
and can be affected by external forces
such as stray electrical current from
other devices.
When connecting the sensor into position
try to keep the cable away from other
power leads
The maximum pressure in the pipes must
not be greater than 1.5 Bar. In order to
extend the life of the peristaltic tube, the
pressure should not exceed 1 bar
Install the pH Perfect control centre
using the supplied fixing kit on a rigid
support (a vertical wall) in an easy to
access location.
Electrical connection
If you are using an external timer
to control your filter pump please
plug the ‘piggyback’ plug located on
the pH Perfect into the timer and
then plug the filter pump into the
piggyback plug. This will create a
controlled time circuit for pH Perfect
with the filter pump.
Now connect the pH Perfect power
plug into a power point to power the
unit up
Electrical Diagram
Warning:
- Acid fumes are highly corrosive
- Do not store acid directly underneath the control unit
- It is preferable to store acid in a safe place outside the filter shed
- If storing inside ensure adequate ventilation is provided
