Never turn on the cleaner unless
it is fully submerged in the water.
Doing so will void the warranty
and may cause severe damage
to the cleaner motors.
Do not use an extension cord to
connect the control unit.
Connect Floating Cable
Contents
Submerge Robotic Cleaner in Pool
2
1
3
Ideal entry point in the pool to avoid
cord tangling and obtain adequate
floor/wall coverage.
Wait for bubbles
to stop completely,
then let the cleaner
sink to the bottom
of the pool.
2
1
5
Never swim when cleaner
is in the pool
"CLICK"
"CLICK"
"CLICK"
"CLICK"
Start Cleaning
4
Press the Start/Stop button to begin cleaning.
1
2
Control Unit
Start/Stop cleaning
Select cleaning mode:
Floor Only
(1h 15 min)
Cleans Floor only
Floor/Walls/Waterline
(2h 30min).
Remove cleaner from the pool
(CX50 only)
3.5 m
Residual Current
Device 240V
CX50 only
Proper Removal from Pool
6
NOTE:
Never lift the cleaner out of the
pool by the floating cable.
Remove the cleaner from the
pool using the handle
.
Use the Lift System
(CX50 only)
on the
Control Unit to drive
the cleaner to the
nearest wall.
Untangle
Unplug
1
2
3
4
*CX50 model only
