Znshine Solar ZXP6-TD60-270/P, Руководство по установке

Страница: 5 / 18

3
the installation method of ZNSHINE SOLAR AUSTRALIA PTY LTD. modules. The mechanical
load shall be calculated by professional staff for system installation according to the system design.
5.2 Site selection
5.2.1In most use conditions, ZNSHINE SOLAR AUSTRALIA PTY LTD. PV modules should
be installed in the position where the sunshine can be absorbed all year round to the greatest extent.
5.2.2The modules should not be covered by the objects such as buildings, trees and chimneys at
any time of all day.
5.2.3 Please don't install in the corrosive environments, such as beaches or land fill areas that are
prone to suffer from pluvial erosion.
5.2.4 Please don't install the PV modules in areas where they may be immersed in water or
continuously exposed to a sprinkler or fountain.
5.2.5 Please don't install the PV modules near the open fire or combustible objects.
5.2.6 The gap and clearance between the edges of module and wall or roof surface should not be
less than 115 mm, so as to avoid damaging the circuit and ensure the smooth ventilation behind the
modules.
6. Installation instructions Clamped installation
6.1 Module overview
The following parts are only suitable for double glass pressing block type installation system
Module name Overview Description
Clamp
Material:
aluminum alloy 6063
EPDM, spring, bolt
Connect each
module