Product Manual - ZMORPH FAB
127
When the cutter is in its lo-
cal position, go to the ‘SET’
menu and set the local 0,0,0
coordinates by pressing the
‘SET X
= 0’, ‘
SET Y
= 0’ and
‘SET Z
= 0’ buttons.
Go back to the main menu
and choose ‘START’. Your
machine will start working.
SET X = 0
SET Y = 0
SET Z = 0
HOME X
HOME Z
HOME Y
Z
X
Y
BACK
MOVE
CALIBRATE
SETTINGS
CHOOSE
FILE
START
BACK
CNC milling workflow
13.7 Tool changing process
If you have generated a milling G-code with tool changes, machine will stop operation at the right moment
and ask if cutter changing process should be executed.
If you selected ‘start
procedure’ you will be
walked through the process.
Using arrows move the
toolhead to a convenient
position. Watch out for any
workholding that may stick
out above material surface.
Choose ‘NEXT’ when ready.
As seen in chapter 13.4 loosen
the collet’s nut. Because your
toolhead is still mounted on
X-carriage, you will need to
slide the 13 wrench under the
toothed belts and find a slot
for it on spindle’s shaft. This
way the positions for X and
Y axis is saved. Replace your
endmill Choose ‘NEXT’ when
ready.
End mill
replacement procedure
START
BACK
Move the spindle to change end mill
MOVE Z
MOVE X Y
NEXT
BACK
Replace the end mill
NEXT
BACK
1mm
10mm
