12
11
Cabinet R
equir
ements
Electrical Connection
Electrical Connection
• The outlet box and supply circuit should be installed by a qualified electrician
and conform to the National Electrical Code or the prevailing local code.
• The voltage used must be the same as specified on this microwave oven. Using
a higher voltage is dangerous and may result in a fire or oven damage. Using a
lower voltage will cause slow cooking.
• The manufacturer is not responsible for any damages resulting from the use of the
oven with any voltage other than specified.
OUTLET AREA
• Anywhere within the shaded area the minimal distance between the appliance
and the wall is 1 3/4.
• The outlet can be located anywhere within the shaded area.
BEFORE INSTALLATION
MWO-24
MWO-30
Cabinet R
equir
ements
GENERAL CABINET REQUIREMENTS:
• 1⁄4” space between the side of the appliance and an adjacent wall or cabinet
door when installed at the end of a cabinet run.
• The cabinet base must be flat and capable of supporting the weight of your
appliance when in use.
• The appliance door will overlap the furniture below by approx 3/16” when
opened.
• There must be an air gap of at least 1/4” between the appliance and the
cabinet walls when the appliance is installed, i.e. 1/8” each side.
INSTALLATION
MWO-24
MWO-30
