CANSwitch-AN2S2
High-Performance Dual-CAN to Ethernet Switch User Manual
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
14
User Manual
When the configuration is successful, it will beep twice. For details about how to use
the ZNetCom software, refer to Section 5 ZNetCom software configuration.
3.4 CANTest Software Operation
We need a device equipped with a CAN port to demonstrate how the
CANSwitch-AN2S2 device realizes bidirectional transparent conversion of CAN network
data and Ethernet data. Here, select the USBCAN interface card, which is convenient to
Figure 3.7 Configuration of the third CANSwitch
Be sure to submit the configuration
modifications
The default password is 88888
A total of three devices are used for
networking. Select 3 as the number of
networking devices (a maximum of 32 devices
are supported for cascading); this device is the
third networking device, so select 3 as the
device number
The baud rate should be 500K, which should
be consistent with the CAN device connected
to the CAN0 port.
The baud rate should be 500K, which should
be consistent with the CAN device connected
to the CAN1 port.
The data of CAN0 port can only be forwarded
to CAN0 port and CAN1 port of device 1;
CAN1 port of device 3
The data of CAN1 port can only be forwarded
to CAN0 port and CAN1 port of device 1;
CAN0 port of device 3
