X-Ray Inspection System
User Manual
P a g e
| 61
Copyright©2021 ZKTECO CO., LTD. All rights reserved.
2)
When the slot of the photoelectric sensor is blocked or jammed, the radiation source
will always be in radiation state. If the radiation light is always bright but there’s no
image on the screen, then the slot of the photoelectric sensor may be jammed by
dust or dirt. In this circumstance, you can use a brush to clean the slot and then
vacuum the dust.
3)
Open the rear of the control console by triangle keys and clean the stubborn dust
inside by a brush or vacuum.
Regular Inspections
If the equipment does not function well because of the following devices or installations,
please contact the technician for consultation and repair.
5.3.1
Inspection of Photoelectric Sensor
Start the equipment and place a parcel on the conveyor for inspection. If images of the
articles can be normally displayed on the screen, then the photoelectric sensor functions
well.
If images of the articles cannot be normally displayed on the screen or the images are
always moving and gliding across the screen, then please clean the slot and surface of
the photoelectric sensor. Conduct inspection again to check whether it performs well.
If the images still cannot be displayed, please contact the technician for consultation and
repair.
5.3.2
Inspection of Conveyor
After working for a long time, the conveyor belt will be unevenly loaded since the weight
and position of articles are not uniform, which may cause the conveyor belt to deviate
from the center position of the passage. In this case, please contact the technician for
consultation and repair.
