20
Stand-by duration
Auto-detection
duration
Scan mode
3-7 Scan mode & some global settings
Scan mode:
Good-read off-
The trigger button must be pressed once to activate scanning. The light source of
scanner stops scanning when there is a successful reading or no code is decoded after the Stand-by
elapsed.
Momentary-
The trigger button acts as a switch. Press button to activate scanning and release button
to stop scanning. The light source of scanner stops scanning when there is a successful reading or
no code is decoded after the Stand-by duration elapsed.
Alternate continue-
The trigger button acts as a toggle switch. Press button to activate or stop
scanning.
Continue-
The scanner always keeps scanning, and it does not matter when the trigger button is
pressed or duration is elapsed.
Timeout off-
The trigger button must be pressed once to activate scanning. The light source of
scanner stops scanning when no code is successful decoded after the Stand-by duration elapsed.
Auto-detection- Good-read off
–
By setting Enable, the scanner will start operating if any nearby object
has been detected. The scanner will stop scanning when there is a successful reading or no code is
decoded after the
must be removed to enable
elapsed. Once the scanner stops scanning, the present object
.
Auto-detection- Good-read on
–
By setting Enable, the scanner will start operating if any nearby object
has been detected. The scanner stops scanning when no code is successful decoded after the
elapsed. Once the scanner stops scanning, the present object must be removed to
.
Working mode of Auto-detection:
In stand-
The scanner must be placed in the stand to enable Auto-detection. When the scanner is not
will be Momentary. Note: This function is only valid when the
is
is always enabled regardless of the placement of the scanner. Note: This
function is only valid when the Scan mode is Auto-detection.
Auto-detection sensitivity:
It is the sensitivity of scanner to ambient brightness change. Sensitivity is
expressed as a percentage value of ambient light change, in the range of 5% to 50%. The smaller the
percentage value, the higher the sensitivity, the easier the scanner will be triggered.
Same barcode delay time for 1D symbols:
This feature is activated only when the Scan mode is in
alternate or continuous mode. Once a 1D barcode has been scanned and output successfully, the optics
module
’
s lights must be off or moved away from the barcode beyond delay time to active a next
scanning on the same barcode.
Same barcode delay time for 2D symbols:
This feature is activated only when the Scan mode is in
alternate or continuous mode. Once a 2D barcode has been scanned and output successfully, the optics
module
’
s lights must be off or moved away from the barcode beyond delay time to active a next
scanning on the same barcode.
Double confirm:
If it is enabled, the scanner will require a several times of same-decoded-data to confirm
Stand-by duration
enable Auto-detection
in stand, the Scan mode
Auto-detection .
Always ON-
Auto-detection
