Barrier Gate-ProBG3000 Series
User Manual
P a g e
| 6
Copyright©2020 ZKTECO. CO., LTD. All rights reserved.
3.1
Adjust the Position of Boom
To adjust the position of the boom, please take the steps as below:
•
Open the barrier gate door and remove the cover.
•
Loosen the two fasten screws of the DZ-1 on the boom shaft with the M12's Allen wrench so that
the boom can be repositioned by hand.
•
Adjust the position of the boom (horizontal position, as shown in Fig. 3.1).
•
Use the torque wrench to tighten the two fastening screws (72 Nm).
Fig. 3.1
Unlocking Arm Manually When Power is Off
When there is no power, the barrier gate maybe in a vertical or horizontal mechanical dead point
position. To unlock the arm manually at suh position of the boom, please follow the steps as
mentioned below.
1.
Lifting the boom: Use the screwdriver to push the crank connected rod away from the dead
point position, lift the barrier gate manually (Push to Unlock).
2.
Dropping the boom: Use hand to pull the crank connected rod down to leave the dead point
position, drop the barrier gate manually (Pull to Unlock).
Adjust the
horizontal screw
