Ziton ZP1-X3E Series, Руководство по установке, Страница: 68 / 114

Chapter 3: Configuration and commissioning
62 ZP1-X3E Series Installation Manual
Expansion board configuration
Adding an expansion board
Use this menu, available from the basic or advanced configuration menus, to
configure the number of installed expansion boards. The default value is 00.
To add an expansion board:
1. Set the display as shown below, and then press Enter.
The Expansion I/O Fault/Disabled LED flashes fast to indicate that the
module configuration menu is active.
2. Select a value using the value selection buttons (2 and 4).
Up to four expansion boards can be installed and configured.
3. Press Enter.
4. Save your changes.
Expansion board configuration
Expansion board labels
For configuration purposes expansion boards are labeled A, B, C, and D.
The label for a given module is defined by its position (left to right) in the control
panel cabinet. The first expansion board installed is module A, the second B, etc.
See your expansion board installation sheet for installation instructions.
Expansion board function and delay configuration
Once an expansion board is installed and added to the control panel
configuration, the following additional configuration options appear on the basic
and advanced configuration menus.
Note: These configuration options are repeated for each of the installed
expansion boards (A, B, C, and D).