OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
Seite 30
TISCHKREISSÄGE / TABLE SAW ZI-TKS 250H / ZI-TKS 250-2VB
ite 30
15)
The riving knife (9) is correctly set when the distance between saw blade and riving knife is
anywhere between 3 and 8 mm.
14.2
Operation
14.2.1
On / Off
Switch on: green button (0)
Switch off: red button (I)
14.2.2
Setting the blade angel(Abb.8)
Loosen the lever (10)
With the knob (8) you can swivel the blade. The tilt angle can be read on the angular scale.
Tighten the blade with (10).
14.2.3
Setting the blade height
The blade height can be set with the hand crank (9).
14.2.4
Setting the angle stop (Abb.16)
The angle stop setting can be changed by loosening the hand knob. Now the angle stop is
free to pivot!
In addition, you can move the angle stop in the guide rail.
After adjustment, fix the hand knob again.
14.2.5
Cutting versions
Longitudinal cuts:
For this purpose use the rip fence. For cuts with a width of less than 120 mm (left or right of the
circular saw blade) is for feeding the workpiece NECESSARILY THE SLIDING STOCK to use.
Cross cuts:
For this purpose has the angle stop to be used. Bring this to the position 90 ° to the blade and place
the workpiece on it. Supportive can e.g. be used with repeated cropping to the same width the rip
fence as an additional lateral support.
Angel cuts:
For this purpose use the angle stop. Adjust the angle stop to the required angle and feed the workpiece
along the angle stop.
F
H
K
Autogoods “130”
130.com.ua