Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Seite23
Elektrický vysavač / Electric Blower ZI-BM870ECO / ZI-SBH3000
13.2.2
Attach shred bag
Hook the first shred bag (7) with the front end of the intake manifold base (5) and rear end on
the suction blower unit. Then move the shred bag adapter on to the suction blower unit.
ZI-SBH 3000:
Attach as described previously shred bag. The shred bag adapter to the suction
blower unit as shown in the picture attached.
ZI-SBH 2600
ZI-SBH 3000
13.3
Electrical Connection
The supply voltage must comply with the specifications that are listed on the nameplate of your
leaf blowers. Leaf vacuum with a nominal value of 230 V can be connected to a mains voltage of
230V.
The leaf blower is to be supplied through a residual current device with a tripping current not ex-
ceeding 30 mA.
An extension cord with too small a cross section causes a significant reduction in the efficiency of
the machine. For cables with a length of up to 25 m, a diameter of at least 3 x 1.5 mm2 is re-
quired, for cables with a length of about 25 m, the cross section must be at least 2.5 mm2.
13.4
Start up
13.4.1
Before starting
Before starting the unit, plug in the power cord and turn on the device. Check if the leaf blower is
working properly.
Make sure that both suction /blower tubes are correctly mounted with the suction /blower unit.
Warning! Before selecting the suction or blower function, make sure that the selector lever
operates smoothly and is not blocked by debris from previous use.
13.4.2
cable strain relief
Plug the Change Extension Connector on the bottom of a
loop device as represented by the strain relief as shown on
the image.
Insert the coupling of the extension cable to the connector
of the device.
As a frequent unplugging the extension cord is avoided.
