TRANSPORT
25
ZI-RBMA1500
•
Before connecting the machine always make sure that it is switches off.
•
Use the machine only when the ON-OFF switch is in good working order.
12.6
Special safety instructions for this machine
•
No bends with deformed, cracked bending tools or bending tools with an enlarged diameter of
the hole (bending sleeve, bending pin, counter pin or stirrup head) may be carried out.
•
The workpiece to be bent must be correctly positioned on the machine using the bending tools
(bending sleeve, bending pin, counter pin or stirrup head).
•
The length of the worktables placed to both sides of the machine should correspond to the max.
length of the workpieces to be bent.
•
When bending several workpieces at the same time, place them one on top of the other in the
recess of the stirrup head.
•
Disconnect the machine from the power supply before opening the electric panel cover.
•
The machine should never be operated unlubricated.
•
No one is allowed to be in front of the machine during the bending process.
12.7
Hazard warnings
12.7.1
Residual risks
Despite intended use, certain residual risk factors remain.
•
Risk of injury (bruising) to hands/fingers due to bending pin and bending sleeve.
•
Risk of injury due to tipping of the machine.
12.7.2
Hazardous situations
Due to the structure and construction of the machine, hazardous situations may occur which are identified
in these operating instructions as follows:
DAN G ER
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARN IN G
Such a safety instruction indicates a potentially hazardous situation which, if not avoided,
may result in serious injury or even death.
CAU TION
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
N OTE
A safety note designed in this way indicates a potentially dangerous situation which, if
not avoided, may result in property damage.
Regardless of all safety regulations, your common sense and your appropriate technical aptitude/training
are and remain the most important safety factor in the error-free operation of the machine.
Safe working
depends on you!
13
TRANSPORT
Transport the machine in its packaging to the place of installation. To manoeuvre the machine in the
packaging, a pallet truck or forklift truck with the appropriate lifting force (the fork must have a length
of at least 1200 mm) can be used, for example.