ZIPPER MASCHINEN ZI-RWM84, Руководство пользователя

Страница: 39 / 54

OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  39
ZI-RWM84
18.3.1 Shortcut keys
Shortcut keys Function Procedure Entry
Spin Mode Setting
Auto spin = Wheel spin after hood is
lowered down.
Manual spin = Wheel spin by
pressing START key.
In calibration program, wheel spin by
press START key.
Factory setting is auto spin
.

Press and hold the STOP key and then press
the C key , hold for 5 seconds until both weight
display windows are turned off.

The spin mode changes when keys are
released and the display window's LED-lights
are on.

Lower the hood to check spin mode status
Weight unit setting
Set the weight units in Gram (g) or
Ounce (oz).

Press and hold the STOP key , then press A+
and A- keys , either oz or g indicator is
illuminated upon the selection.
Self Calibration
To enter the balancing calibration
program.

Press both Fn and C keys to enter self
calibration program.
Distance value A calibration
To enter the Distance A calibration
program.

Press Fn and A+ or A - keys to enter
Distance A calibration program.
Nominal size W calibration
To enter the nominal size W
calibration program

Drücken Sie die Tasten Fn und die
Tasten W+ or W-
,
um den Wert der
Nennweite einzugeben.
Nominal diameter D calibraton
To enter the nominal diameter D
calibration program

Press F n and D+ or D- keys to enter
Diameter D calibration program.
Save the User's presetting data
To preset data in each user's
environment

Press the user key to switch to the selected
user
. Enter A, W and D data, then press
Fn and USER keys to save data into the
selected user environment.
Optimization (OPT) Program
To enter the OPT program.

Press both Fn and Vehicle-MODE keys
to enter OPT program.
ALU Program
To enter ALU 1-5 programs.

Press both Fn and ALU keys to enter
ALU1-5 program.
18.4 Mounting the tyre
 Select the appropriate cone for the size of the
tyre centre hole and slide it onto the threaded
shaft.
 Slide the tyre and then the clamping cup onto
the threaded shaft.
 Lock the tyre and pressure cup with the quick-
release nut.
NOTICE:
Carefully place the tyre on the threaded
shaft. (Do not slide back and forth with the
center hole of the tyre on the threaded shaft).
The threaded shaft can be damaged over time.
In the following you will find alternative methods for a quick mounting of the tyre using the quick
release nut.