ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
25
ZI-LBR40V-AKKU
12.3
Remaining risk factors
W A R N I N G
It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
Risk of injury due to noise:
Working for a long time can damage your hearing if you do not have a very good hearing protection.
Risk of injury due to the working area:
Solid objects, stones, metal parts, or the like can be thrown out!
Risk to the hands or fingers:
Do not grab in the connecting piece or blow pipe while the machine is running.
Risk of injury due to pick up and roll up:
Wires and cords can be detected by the cutting tool and can damage the machine and can cause
injuries. Unplug battery and safety switch (if equipped) before removing the deposits!
Risk of injury due to vibration:
The declared vibration emission value has been for a standardized test is measured and can be used to
compare one tool with another electric are.
The declared vibration emission value may also be used for a preliminary assessment of exposure.
Rotating parts
Be rotating parts mounted incorrectly, this can lead to serious accidents.
Check before starting work, the cutting blade for tight fit
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
In spite of all safety is and remains her healthy common sense and their corresponding technical
qualification / training for use of the machines most important safety factor!
