TROUBLESHOOTING
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
26
ZI-BTS350
14.3
Cleaning
14.4
Storage
If the machine more than a month is not used, please follow these instructions:
Entire remove fuel from the tank, fuel cock and carburetor.
Water from the tap and remove line (this is to do in cold weather after each use)
Remove spark plug, pour about 1 tablespoon of engine oil into spark plug hole
Engine switch to the OFF
Operate starter rope several times
Spark plug insert
Generator in a dry, well ventilated place, cover.
14.5
Disposal
Do not dispose of your waste in the ZI-BTS350. Contact your local authorities for
information regarding the available disposal options. Improper disposal can lead to
contamination of soil, ground water soil seepage of hazardous and noxious substances,
and thus reach finally through contaminated water into your food supply and your
health. Replace your old unit with a new one at your local dealer, is obligated to take
back your old equipment free of charge for the purpose of proper disposal.
15
TROUBLESHOOTING
Trouble
Possible Cause
Solution
Engine will not start
ON OFF switch to OFF
Fuel filter clogged
Great power tank empty
Spark plug is defective or loose
Spark plug gap set wrong
Switch in the On position
Fuel filter change
Fill the fuel tank
Clean or replace spark plug
Check the correct setting
Engine stops after
starting
Idle speed
too low
Clogged
fuel filter
The fuel tank
is empty
Adjust
idle speed
Change the fuel
filter
add fuel
Less engine power
Dirty air filter
Clean or replace air filter
Bade does not run
V-belt
is defective
defective clutch
Change
belts
machine repair
Blade runs bad
cutting wheel
shaft
Check
ball bearings
, shaft,
flange and
nut.
Replace
if defective
N O T E
Cleaning: The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners
will result in damage to the surface!
Therefore:
When cleaning, use only mild detergent