OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
27
ZI-RWM99
16.3.3
Connection to the power supply
W A R N I N G
High electrical voltage! Connection of the machine to the power supply by persons
who are not specially trained in the handling of electricity (electricians) can lead to
serious injuries or death. The machine may therefore only be wired by persons
specially trained for working with electricity (electricians)!
Observe the information on voltage and frequency on the type plate on the back of the
machine!
It is recommended to provide the machine with its own electrical connection via a suitable
circuit breaker.
The mains cable of the machine should be fitted with a plug that complies with the applicable
regulations.
When connected directly to the mains control without plug, it is advisable to lock the main
switch of the balancing machine with a padlock so that it can only be operated by authorised
persons.
16.3.4
Calibration
For proper operation, the instrument must be calibrated after installation and connection to the
power supply. In addition, calibration is always advisable if there are doubts about the
correctness of the displayed measurement results.
17
OPERATION
17.1
Mounting the tyre
1.
Select the appropriate cone for the wheel center hole and
slide it onto the threaded shaft.
2.
Slide the wheel onto the threaded shaft.
3.
Lock the wheel using the quick-release nut.